Defect #8012

Wrong selection of modules when adding new project after validation error

Added by Maxim KruĊĦina almost 9 years ago. Updated about 8 years ago.

Status:ClosedStart date:2011-03-29
Priority:NormalDue date:
Assignee:-% Done:


Category:Project settings
Target version:1.1.3
Resolution:Fixed Affected version:1.1.1


I'm creating new project.
On New project page I filled entire form, clicked Save.
There was an error, so page reloaded, in the upper part is error in red field.
All form elements are rendered in correct state (I believe), but Checkboxes in Modules section are all turned on, even I preselected only few of them.
Correct behaviour should be that selection of modules will keep the same as selected by user.

Associated revisions

Revision 5265
Added by Jean-Philippe Lang almost 9 years ago

Modules selection lost on project form after validation failure (#8012).


#1 Updated by Etienne Massip almost 9 years ago

  • Target version set to Candidate for next minor release


#2 Updated by Jean-Philippe Lang almost 9 years ago

  • Status changed from New to Resolved
  • Target version changed from Candidate for next minor release to 1.1.3
  • Resolution set to Fixed

Fixed in r5265.

#3 Updated by Jean-Philippe Lang over 8 years ago

  • Status changed from Resolved to Closed

#4 Updated by Bertrand Dubose about 8 years ago


Also available in: Atom PDF